Wall Penetrations Done Right
Horizontal core drilling lets new pipe, duct and conduit pass through concrete and masonry walls without hammering, oversizing or patching. We wall-mount our drill rigs with bolt-down or vacuum bases so the bit runs straight and true — level, or at the precise slope or angle your design calls for.
Angled coring is ideal for drainage lines that need fall, vent and exhaust runs, and penetrations that must pass between obstructions. Tell us the angle and we'll set it on the rig.
Typical Horizontal & Angled Work
- Water, sewer & gas service entries
- Dryer vents & kitchen exhausts
- HVAC line-sets & duct openings
- Electrical service & telecom entries
- Foundation & stem-wall penetrations
- Seawall, retaining wall & weep holes
- Lift station & manhole connections
- Angled drainage & sloped pipe runs
Built for Florida Jobsites
- Exterior and below-grade work in tight trenches and crawl spaces
- Sealed-ready, smooth holes for link-seal and grout
- Low-vibration drilling safe for occupied buildings
- Matched to sleeves and pipe OD for a tight fit
Horizontal & Angled Drilling FAQs
Can you drill at a slope for drainage?
Yes. We can set the rig to the exact angle or slope your drain or vent line requires.
Can you drill through a foundation below grade?
Yes, as long as the area is excavated and safe to access. We core foundations, stem walls and vaults for utility entries.
